Original subtitles

So in this one we're going to add the walls to the first floor of this house.

So let's get started.

So the first thing I'm going to do is just come over to the lawyers tab and switch off the ground floor.

I can switch on my first floor plan and switch off the ground floor windows just a couple of things

we could do here.

We could maybe if I switch back on the ground floor we could copy this and move it up and manipulate

it.

The only problem is you lose the ability to manipulate it correctly.

So that's not really a Gore.

The only thing you could do I switch off this is you could select the section tab into edit mode.

You press a once or twice you can extrude up you'd have to come in here add edge loops and connect up

some of the pieces that need to be connected top and bottom of the window for example.

So that's not really an option either.

So I'm just going to control this and that's going to come back to object more.

I think the hardest thing to do really is use the pack and again and create more walls.

So to begin this one again press 7 which is selected I'm going to tap into edit mode when we come over

here shift as cursor to select it I back to object mode and up to create I'm going to select wall so

the width of this wall is going to be 30 centimeters.

So I'm going to type in 30 cm I can press key X.

It's not that over.

Why in the SNOPT is back here.

So if I select this arrow I can snap this up I can increase the number two to grab this arrow here and

SNOPT this over and so on.

Increased number two tree and drag this down here.

OK.

And rather than increase the number to four I can just hit close.

OK.

And that closes that off for me.

Ok so I'm going to do something similar.

The internal walls I'm going to select is press 7 again and tap into edit mode.

I'm going to zoom in here and select an insertion point press shift s and cursor to selected TAB back

to object mode.

Now I'm actually going to minimize the Arki mesh.

So here I'm going to select Well OK.

And for the do with I'm going to change this to 15 cm I compress gx and I didn't hear g y.

Maybe it's not.

So I'm going to increase the number two tree because that's what I'm going to need here.

So what I need to do really is just rotate this by 180.

So I'm going to press or that one at zero.

OK.

And then I can just press g y SNOPT or up here g x.

It's not done over here.

So if I increase the length of this I can snap this down crystal into this one I can snap it up and

snap this one up here.

OK.

So that's what I'm going to do.

I'm just going to go ahead and add the other walls into this structure.

OK so that's relatively straightforward.

OK.

And I think that's going to do it for this one.