Original subtitles

In this video, we are going to create that example, 13 drawing file attached with this picture.

As you can see here, this is the example that in drawing that we are going to make.

As I have said in the earlier video, you have to select the center of the drawing and make it first

so that the other areas can be made directly by using the reference of the center portion.

Like in this drawing, if you analyze, you can see this area in the center portion about which this

area is referenced by this and 80.

Also, there are these areas and these areas which we need to make directly by using this center portion.

So first will create this center position.

Let us start.

First, we'll create a circle.

I take its origin as the center and create a circle of radius, valuating into the circle a bit up.

Now I'll take another circle, maybe somewhere here.

That is constrained is the dimension from this horizontal to this point.

This is a valuate and vertical axis to the center.

This is also pretty.

The diameter.

Aurelius is of value 50, not just another circle will take this is the center.

This has a reduced value of 30.

DoubleClick online make a line somewhere here and a line somewhere here.

Both are vertical lines.

This line and this circle and give it tendency constrain similarly this line and this circle tendency.

Double click on Quick Trim Trim, this extra portion, this extra portion, this, this and this to

ARC's.

We've achieved the lower portion.

Now, let us create this small, small area so the proportion let us take profile, zoom into that area.

The horizontal line and another vertical click on this skip key.

Now, I take this line and this line about this vertical axis.

Will create symmetry, the dimension between this horizontal and this line.

Is of value 50.

And the distance from this line to this length.

He's off then.

Now we'll take a quick trim, double click on it, this portion, this portion and this portion.

Now, let's take a profile again.

Take a line somewhere outside a vertical and horizontal line.

Prevent these dotted lines.

It is creating a problem.

So let me create a Angoulême.

And particularly press the escape key to exit from the command and I'll take this line and calculated

horizontal.

You can see it is moving somewhere so I can track it and keep it wherever I request.

Now, I take this line and this circle.

Were tangency constrain?

Now, double click on this dimensioning.

The dimension of this line is then.

The length from this access to this line, this is a value 40.

You can see it is completely constrained, no prisoners to exit from the damaged Inkerman.

Let us double click on Quick Trim, trim this portion and this portion.

No, let us create a circle at the center.

I can click here.

Give it a value of 15.

Now, only these two lines are left out, which are connections between this top and bottom portion.

Take line.

I'll click where the automatic constraints are not interfering.

Click here now select this line and this circle tangency.

This line and this circle.

Tendency immediately ultimate quick trim disposition and disposition.

Now I'll think of the other side.

Line.

From this point to this circle, you can see I can use the power of automatic constraint.

You can see the tendency caution is automatically getting created.

You can use this or you can create it here and give it a tendency constraint.

It's your wish.

Let me use this automatically and you can see this.

The tendency is simple click and the tendency constraint is automatically created.

Now, take quick time and select this portion.

And you can see we have created a fully constrained example, 13 drawing required in this video.