Original subtitles

This is tutorial number 34, we will talk about the whole feature.

And we see it here on the right side, whole.

So first let's take a point, where we want to make our whole.

So let's point here on that surface, let's activate the whole.

So as you notice here, the place we were clicking.

And now you have the preview window here, you can see the type of the hole you want,

even to make up the next through the hole.

Or if you have a surface in between or through all the last give you the hole cut through the whole part,

or up to plane if you have plane or surface.

So I'm going to make it to plane.

And here you have the types of holes you have, depending on your design or what you want,

gathered and all these types.

And I'm going to use the counter.

And here you have the outer diameter.

You can, for example, make it 20.

And for the depth, you can make it 4 millimeter.

And here you can choose if you want to make a thread or not.

So you can activate the thread.

And here you can specify the thread dimensions.

The type, thread, hole, and so on.

So let's click on preview.

So we have created the hole.

And if we want to make the place of the hole, change the place, you can push in the sketch.

And let's make some diameter or some dimensions.

Let's make dimension to be 4 is every 15.

And now when we are done, we can't accept the editing or positioning.

Okay.

So we have our hole created.

So this is a lot of time.

In case we want to make it with the traditional pocket, we need to make many sketches.

And put them or cut them.

And the hole is more specific and more visional to use exactly the type of the bolt you are going to use.