All language subtitles for 29_EN.

This is turn number 29 about the pocket. We created this profile and made a pad from them.

Now let's sketch on that surface. Create a circle on the center of it and set and let's use the pocket feature.

Here you can specify the type of cut inside. Either to make it a 40mm preview. We have extruded that for 50mm.

Now we have this cut. Not through all this part. You want it to be through all. You can make it up to next.

Or up to last give you the same result. For up surface you can use this last surface.

Now we need this cut.

Again, let's create a sketch on that surface. Let's create a rectangle and set pocket.

Let's make a dimension. If you reverse the direction to the other side, it will be unnecessary.

Make sure you are cutting on the right side. Let's make a preview.

Now let's try to create a sketch on that surface.

Now let's make a circle here. Let's make a circle. Now let's activate the pocket. Here we can make up the next.

Now let's cut through all. If you make it just a dimension and let's make the dimension to be 100mm.

Let's click on the mirror extend. It will make a cut also for 100mm mirror on the second side.

Now let's make a preview. Then press Ctrl-C. Also you can make this issue with using.

For example, let's make this for 80mm preview. Now let's cut on the other side without cutting this part.

Now let's make a preview. You can click on the mirror. You can click on the mirror.

You can click on the mirror. You can click on the mirror.

Now let's go to the third solid part and show another.

Let's create a sketch on this. Let's make a circle. Set the pocket.

Next time we will make up the next. We will activate the thick. We will make a thickness of 2mm preview.

Now let's make a thick cut inside this solid part.

I hope this lesson about pocket was useful. In the next tutorial we will talk about the second type of pockets.