Original subtitles

How to check that the

hydraulic system in your condominium is working correctly.

The first thing you should do is check the meter's operation

to ensure it works properly.

To do this, you should check the following that is turned on that

it is not displaying an error that the numbers are working.

Make sure that the main switch on the outside of the condo has the switch

facing up to confirm it is on.

Next, check the circuit breaker box inside the condo

and ensure the breaker is on by confirming that the switch is facing up.

If you decide to install more expensive electrical equipment

such as air conditioners,

it should be done separately from the existing circuits

because they can be overloaded and damaged.

Make sure that the general shut off valve on the hydraulic line is open.

To check this, make sure that the key is in the same direction as the pipe.

This way it is open.

Confirm that the heater bypassed shut off

valve is in the same direction as the piping.

This valve is used to feed the hot water

line to the condo.

Verify that the electric motor

is connected to electrical power.

All electric motors are configured with a pressure of 2.5 kilograms,

which is sufficient for the condo installations.

It is not necessary to install any attachments if, after completing

these steps, there is still no water in your condominium.

Please report the problem to maintenance for assistance.

Please refer to your owner's manual for more information about properly

using your condominium.