Original subtitles

Welcome back in this tutorial we will create one object using shaft command.

So we want to create this pulley with web.

So let's begin click on start mechanical design part design.

Now we want this object to be vertical.

So for that we will create sketch on vertical plane.

So click on sketch.

Suppose we will take this plane.

Now for shaft command we have to create this hatching hatch profile.

Then we will have to revolve it around this axis to create this object.

As this object is symmetric so we will make it half and mirror it.

So at first create one axis around which we want to mirror it.

Then create this shape like this.

Use profile create the shape.

And press escape to come out then give the parameters.

So outside diameter is 90 that is 45 from the center.

So constraint from the edge the line height will be 45.

Then next is 80 that is 40.

So give that dimension from here constraint click on constraint.

This one this is 40.

Then next is internal hole.

So internal hole is of tire 20 that is 10 distance.

After upper line will be at 40 diameter that means 20 distance.

So give constraint edge this line will be at 20 distance.

And internal hole is of 20 that is 10 distance constraint edge this line will be at 10 distance.

Then next is width width is 35 that is half 17.5.

So again constraint this width is 17.5.

And then internal internal is 5 that is 2.5 on either side.

So constraint this line and this line 2.5.

So in this way.

So all parameters has been defined.

So now we have to mirror it around this axis.

So select the complete profile.

Click on mirror select this center axis and it has been mirror there.

Then next will be to define the axis of revolution.

So this is the axis of revolution at the center.

So there we will create one axis.

Click on the axis and create this axis.

Around this axis we want to devolve.

Then exit workbench click on exit workbench and click on shaft and preview.

So in this way this pulley width wave is created around that axis with desire parameters.

Then click on ok.

Then we will need this key wave.

We want to cut this key wave 6 by 3.

So for that sketch click on the surface zoom fit.

Then suppose create one rectangle.

Again this rectangle needs to be symmetric around this axis.

So create one axis.

Then press control and select this line and this line and axis.

And make it.

Click on constraint defined in dialogue box click on symmetry.

So it will remain symmetric.

Then we want this dimension to be 3 plus internal 10.

At least 13.

So using constraint we will give from edge this side as 13.

And divide this 6.

So again constraint select this line and give dimension of 6.

Then exit workbench then click on pocket and give up to last.

Ok.

So in this way this key wave also created.

We should read with this.

Zoom fit.

So in this way you can create a pulley with wave using sharp command.

So that's all.

We will stop here.

Thanks for viewing the tutorial.

If you want to see the next lecture visit here.

If you want to see the next exercise visit here.

If you want to view the complete playlist for Katiya visit here.

And if you want to subscribe this channel you can subscribe from here.

So this all.

We will stop here.

You